• 2-1/2” square column (mast) with black oxidized finish
• 6” wheels for easy mobility
• Dual switch/outlet control panel with amp meter (except for CB700 models with LED amp meter)
• Vacuum pump for quick mounting to flat surface without drilling an anchor hole (included with combination rig)
• 4 leveling screws on the base
• Up to 14” bit capacity with one spacer block
• Slide handle allows for drilling in tight areas
• Combination base is a quick change over from vacuum to anchor base
• Ceiling jack helps keep the rig in place as a backup for anchoring or vacuuming the base down (used with a brace piece-2 x 4 or other material)

Powernail 16 Gauge Hardwood Flooring Cleats
1/2" to 33/32" tongue & groove hardwood flooring cleats for use with the 445 PowerNailer.

Drywall Screw Gun 

Dewalt Jig Saw

1" Air Impact Tool

3/4" Air Impact Gun

1/2" Drive Air Impact Gun

for pressure washing high areas.

For shooting Nails in Cement or Steel

Shindiawa Weed Eater

Meterman Measuring Wheel

One Man Auger Drill 4", 6" and 8" holes 36" deep.  

24" magnet sweeper for picking up nails after your roofing replacement.

hammer drill bit of all sizes for concrete and masonary.

Hitachi 4-1/2" angle grinder

1/2" Gas Engine drill 

3/4" magnetic base drill

Wet saw for cutting brick and block

7-1/4" Circular saw

Ridgid Pony 700 Threader

Heat Gun

Roof Pro 455XP Coil Roofing Nailer

14" Metal Cutting Chop saw used for cutting any ferrous metals such as rebar, steel studs, pipe, threaded rod, angle iron, etc

This bull float is made from lightweight magnesium, and is used to level and smooth the surface prior to finishing. Magnesium floats provide a smoother finish than wood floats